Cabling Heckweck

Raisch rear wake kit for Triumph Bonneville, Thruxton & Scrambler. With this kit the bike gets a completely clean rear. Without the big original rear fender and without the original rear traffic lights made of plastic.The most minimalistic and elegant rear kit available on the market for these motorcycles! Due to the rear under fairing (aluminum lower plate) there is a good splash protection. A LED license plate light with E-number is also included. License plate holder as well as subplate are precisely laser cut from aluminum in Germany & black powder coated.It also comes with a plug that fits into the original wiring harness. That is, only turn signals, lights, etc. must be crimped and can then be connected without having to change anything in the wiring harness.All other cables, connectors, screws, etc. that are needed for installation are of course also included. Since the HeckWeck kit does NOT have a central tail light, it is mandatory to have 3in1 turn signals (these combine turn, tail & brake light in one turn signal).Further down in this description you can order the turn signals in a set and get 10% discount on the turn signals.All turn signals listed here are with E-number and street legal. If you don't want to wire and crimp the enclosed cables, plugs & insulations by yourself, you can order this service as well (you can add it to the set below). The Kit is available in 2 versions Version 1: The turn signals are mounted with a retaining plate from the inside of the strut. When the ignition is off you almost think at the motorcycle are no turn signals on it (but you see them well enough when they light up. Is not so Stvo compliant, because the turn signals are too far in the rear. Version 2: The turn signals are mounted directly on the license plate holder (turn signal holder are with the license plate holder). Legal and StvO compliant. To have the kit 100% legal, a reflector must still be attached to the license plate (you can also find it below & add it to your kit). Matching / same turn signals for front you will find at the very end of this description under the accessories.   

Lateral license plate Thruxton, Bonneville & Scrambler, attached to the strut. For all who have their license plates on the side and on the middle height of the motorcycle want to have their rear already free and clean. In the kit is the license plate with license plate illumination, a complete cable set for the wiring of turn signals, taillight and KZ luminaire, & a fitting instruction. If you do not want to crimp and solder the cable kit yourself, we also offer this as a service (see accessories in this description). Optionally you can order the kit with an underfloor plate (this serves as a splash guard if you do not want to have a mudguard installed anymore). The kit is ideally suited for mounting a taillight / turn signal combination (see accessories in this description). Alternatively, a short aluminum mudguards with classic old school taillight and chic turn signals would look (simply in the lighting category rummage). There are several points at which the turn signals can be installed in conjunction with the license plate (you can find all the suitable turn signal holders in the accessories of this description).