Notched nails R9T Drill / drive in carrier plate

Also the footrest support plate and the heel guard, like most metal parts on the R9T's, have the unsightly die-cast surface, which does not look very noble. But we can also powder coat them black! Attention! With this article you order ONLY order the SERVICE that we powder coat your original parts. So you have to send us your parts and we will send them back after we powder coated them in black. Many would like to have a black footrest. The first consideration would be a completely new detent system, e.g. from LSL or Rizoma, which is clearly the most beautiful solution. But if that is too expensive for you, you can get a cheap alternative by having the carrier plate and the heel protection coated in black, ordering black detents and a black gearshift (you can find suitable articles under the accessories products in this description). You just send us your two footrest support plates + heel guard right, we sandblast them, stick all parts that have to remain free and coat them black (RAL9005) The brake light switch is attached to the detent carrier plate with 2 notched nails ex works. These must be drilled out for coating and then hammered in again (you can order new notched nails with the switch, see accessories in this description). If you do not want to do this work yourself, you can order the article "Drill / hammer in notched nails R9T carrier plate" (see accessories in this description). Duration until you have your part black coated again: approx. 2 - 3 weeks.