Magura Mx Fat Bar

Product information "Magura Mx Fat Bar"

The Magura Mx handlebar (suitable for all 22mm bikes) is the handlebar that gives the rider the most control and power over the bike and front wheel. A nice wide and almost straight handlebar that provides a very sporty but also comfortable sitting position.
You have to like it in any case to grab wide when driving, otherwise this handlebar is not the right one for you!
In addition, the handlebars give the bike a very cool look with its straight and little cranked line. It almost looks like a motocross or a supermoto.

We can only warmly recommend this handlebar! We also drive on our own Scrambler conversion. Simply exactly the right one for everyone who likes to drive sporty and likes the look!

Since this is a FatBar handlebar (i.e. at the clamp it has 28mm diameter and then runs conically to 22mm towards the fittings), a new clamp is needed (see accessories in this description).
Our recommendation here is the 35mm clamp, so you have the perfect sitting position on the bike.

All wires & cables are long enough and do not need to be replaced.

Dimensions handlebar (see photo): a: 808mm b: 135mm c: 189mm f1: 120mm h: 63mm

Models Triumph AC until 2015:
  • Bonneville SE Gussrad
  • Scrambler EFI
  • Scrambler Vergaser
  • Thruxton Vergaser
Triumph AC bis 2015
Bonneville SE Gussrad
Scrambler EFI
Scrambler Vergaser
Thruxton Vergaser
0
0
0
0

Please enter a valid email address.
Please enter a valid question.
Fields marked with * are mandatory.

There aren't any asked questions yet.

Zubehörartikel

Fat Bar Handlebar Riser CB00257M / RS17
Fatbar for Scrambler or Bonnie cast wheel. . Away with the small 22mm standard handlebar. Black handlebar mount + 10 mm resp. + 35mm for original fork bridge with handlebar mount 28,6 mm. The handlebar runs conically to 22mm outside. Therefore, of course, all fittings fit. This makes for a much more massive & mature look on the bike, as the original 22mm handlebar looks very puny.Matching the thick clamps we also offer 2 matching Fat Bar handlebars. One from Magura & one from LSL. See accessories in this description.

From €94.95*
Drilling template fittings / handlebars 22mm CB11954 / RS600
When installing a new handlebar or stub on all Triumph models with standard 22mm or FatBar (inside thick outside 22mm) handlebars, it is necessary to make two holes in the new handlebars. Over it the original fittings are then locked. Because it is not easy to drill a hole in round material (like a handlebar) and they have to be exactly opposite, we offer this drilling template. This is simply put around the handlebars and screwed together. So it is very easy to drill the two holes exactly opposite each other.

€34.95*