Speed Lowering Bonneville LC

This lamp holder kit offsets the original headlight and the speedometer of your Bonneville T120 & T100. Whenever you look at a Bonneville or see photos, you think yup a really chic classic, but something just does not fit 100%. Something is not right in the front part! The headlight and the speedometer sit just too high, which does not fit perfectly in the line of the bike.So we have developed a kit, with which the headlight and the speedometer is set about 3cm lower. Also, the headlight comes 2cm closer to the motorcycle.Due to the deeper seated speedometer, this nestles much better to the triple clamp even in the top view. So it looks like he would fit perfectly to the triple clamp and no longer as if he was just somehow screwed to it (see pictures).Also, a nice side effect is that the regulator has to be moved from in front of the triple clamp behind the water cooler. If you are worried that it might get too hot there, you are wrong. Triumph installs the same regulator on other models from the factory also behind the radiator. The lamp holders have an 8 hole, for mounting turn signals. Pretty much all accessory turn signals on the market have an M8 thread and thus fit into the hole (who wants to continue to use the original turn signals, you have to drill yourself a second hole). We recommend to the kit the Motogadget Tens or Pin turn signals, which simply fit best to the holders (see accessory article in this description).If you do not want to mount turn signals on the brackets, we recommend ordering a pair of turn signal plugs (see accessory items in this description). The kit consists of: Stainless Steel Heeadlight Holders Speedo lowering Regulator relocation Rarely have we had a part in our range that brings such a positive change to the bike with so little effort. Since pictures say more than a thousand words, just look at the pictures! IMPORTANT! click on the pictures and look at them in large, because then they are moving pictures that show the change from original to lowering. The kit is available in either Black (lamp holders are black powder coated) or Raw (the stainless steel lamp holders are hand brushed). All cables are long enough for mounting the regulator routing. All cables are long enough for mounting the controller routing. However, under certain circumstances, a piece of the wiring harness must be stripped in the steering head area, so that you have more cable length available. To insulate this again neatly, we offer a high quality fabric tape with, which you can find under the accessories in this description.An assembly instruction is of course also supplied. Our Alcatraz lamp grid fits especially well to the kit (is also installed on some of the product photos). The grid can also be found under the accessories in this description.